Once the device is found in the connection wizard, click on the name.Ħ. In the example below, the microPod II device name is “wiTECH 1.0 microPod.” It has been discovered over Wi-Fi and USB.ĥ.
Open the wiTECH Diagnostic Application (wiTECH 1.0) and look for the microPod II device in the connection wizard.Ĥ. Use the following link to add a wireless profile to the microPod II, if not already done: ģ. Connect the microPod II device that will be used with Enhanced DRB III Emulator to a Windows computer that has the wiTECH Diagnostic Application (wiTECH 1.0) either through the USB-microUSB cable or by plugging the microPod II device into a vehicle’s OBDII port and having both the microPod II device and the computer on the same wireless network.Ģ. This microPod II Device will only work with the wiTECH Diagnostic Application (wiTECH 1.0) and Enhanced DRB III Emulator.ĭRB3 Emulator: Worked with MicroPod 2 or VCI Pod?ġ. This is different that those for the wiTECH Diagnostic Application (wiTECH 1.0) or the Original DRB III Emulator.
#CHRYSLER DRB3 EMULATOR INSTALL#
In order to install DRB III Enhanced Emulator you must have a microPod II Device that has Entitlements for the Enhanced version.
#CHRYSLER DRB3 EMULATOR SOFTWARE#
The wiTECH 1.0 can be downloaded and installed on a Windows PC from DealerCONNECT (DealerCONNECT > Service > wiTECH Information (Under the SERVICE TOOLS & EQUIPMENT section) > Legacy Tools > wiTECH Software Installer).
In order to install the Enhanced DRB III Emulator, you must have the wiTECH Diagnostic Application (wiTECH 1.0) installed as well as all supporting software. Attach DRB3 emulator download link!ĭRB III Emulator is the exact scan tool software application used in Chrysler, Jeep, and Dodge dealerships to service non-CAN based vehicles from 1998-2007. Here are steps to install DRB3 emulator for Chrysler diagnosis and programming.
0 kommentar(er)
